Days Strider MD 3 Specifikace stáhnout pdf (Strana 32)

Issued: 28.02.2005

Strider MD 4 Plus

6.3 Overload protection - motor protection

The overload protection system switches the drive off if the motor

becomes overloaded by trying to climb over too high an obstacle such

as a kerbstone, or if you try to climb to steep an incline.

Should the overload protection system activate, the motor or power

module has overheated. This can be caused by driving up long inclines

with high load and/or under high environmental temperatures.

Activation of the overload protection trip should be seen as a warning to

inform users not to continue driving under present conditions.

If activation occurs on an incline, then the incline is either too steep or

the duration of driving on the incline is too long. Continued driving on

such an incline should not be continued - even if the overload protection

device allows you to do so. The motor could become dammaged by

such sustained excessive temperatures.

If the motor is overloaded, the following happens:

• the Strider becomes noticeably slower and then stops

• the control system switches the Strider off

Tipping hazard!

There is an increased tipping hazard if the incline is very steep.

• Try to get help from a second person when turning your

scooter round.

To rectify this:

Switch the scooter off and allow it to cool down for a few minutes.

Switch the scooter on again and ...

... reverse away from the obstacle (such as kerbstone) and then

try again at a lower point.

... be careful turning the scooter round on inclines, and always

reverse away very slowly.

➨

Driving information

Accident hazard in push mode!

If the incline is too steep, there is a danger that you will not

be able to hold onto the scooter and that it will roll down the

incline uncontrolled.

• Try to get help from a second person when turning your

scooter round.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 91 92

Žádné komentáře

Days Strider MD 3 Specifikace Strana 32